|
• Color TFT folding color LCD : 10.2” color TFT
folding LCD
• 9 crystal pulse wave Doppler transducer
• 152mm wide paper (US/International standard)
• Built-in rechargeable battery
• Accurate fetal movement detection and accounting
• Central monitoring interface
• Type8010 Options: Maternal SpO2, MHR, NIBP,
Twin FHR,ECG, RR, Temp., FAS(Fetal Acoustic Simulator)
|
ECG(option)
• Meets IEC60601-2-27:2005 and AMMI EC13:2002
• Integrated the 3 channels of ECG analog circuits,1 channel of respiration and 2 channels of body temperatures,
the YSI400/YSI700 is available by software configuration.
• With cardiac output monitoring
• 13 arrhythmia analysis
NIBP(option)
• High accuracy, Very good repeatability
• Quick inflation and deflation
• Two pressure sensors, overpressure protection with hardware and software
• Can be used on neonates and infants
SpO2(option)
• Analog SpO2, perfusion rate is 0.1%.
• The safe and solid sensor with low radiation power and without power inside
• Less influenced by movement
• Less influenced by electrosurgical unit
Technical Specifications
|
| Fetal Heart Rate |
| Transducer |
Multi-crystals, pulsed doppler , high sensitively |
| Strength |
<5mW/㎠ |
| Working frequency |
1.0MHz |
| Signal processing |
special DSP system and modern reorganization. |
| Measurement range |
50~210bpm |
| Alarm Range |
| High limit |
160,170,180,190bpm |
| Low limit |
90,100,110,120bpm |
| Maximum audio output power |
1.5 Watt |
| Toco |
| Measurement range |
0~100 units |
| Display |
| The LCD displays FHR, TOCO, FM, maternal parameters, time, date, and volume, etc., It can store and playback the data. |
| Power |
Type8007
- AC 100-240V, 50/60Hz, 8.4V Li-ION battery
Type8010
- AC 100-240V, 50/60Hz, 16.8V Lithum battery |
| Power Consumption |
< 20W |
| Dimension |
Type8007 : 295W×240D×73H(mm)
Type8010 : 320W×350D×85H(mm) |
| Net weight |
Type8007: 1.75kg, Type8010: 3.5kg |
| Environment(Working) |
Temperature: +5℃ ~ +40℃ |
| Humidity: < 85％ |
| Atmospheric pressure: 86kPa ~ 106kPa |
| Environment(Transport/storage) |
Temperature: -10℃ ~ +55℃ |
| Humidity: < 93％ |
| Atmospheric pressure: 86kPa ~ 106kPa |
| Transducer Acoustic Output |
| Under the requirements laid down in IEC 1157, 1992, the peak negative acoustic pressure |
| does not exceed 1Mpa. The output beam intensity does not exceed 20mW/㎠ |
| and the spatial-peak temporal-average intensity does not exceed 100mW/㎠ |
| Maternal SpO2 measure(option) |
| Measure scope |
70% ~ 99% |
| Measure accuracy |
±3% |
| Pregnant HR Measure(option) |
| Measure scope |
30bpm～240bpm |
| Measure accuracy |
±2bpm |
| NIBP measure(option) |
a) NIBP-SYS (6.7~32.0Kpa)(50 ~ 240mmHg) |
| b) NIBP-DIA (3.4~26.6Kpa)(25 ~ 200mmHg) |
| c) NIBP-MEAN(2.0~24.0ka(15 ~ 180mmHg) |
| NIBP Accuracy |
±1.1kPa（±8mmHg）or ±5% of the results, take the bigger one. |
| Maximum Mean error |
±5mmHg |
| Maximum Standard deviation |
8mmHg |
| Pulse Rate Accuracy |
Maximum Mean error : ±2bpm |
| Measure accuracy |
±2bpm or ±5％ of the results, take the bigger one. |
| Measure mode |
Manual / Auto |
| ECG(option) |
| CMRR: |
≥90dB |
| Heart Rate Measurement and Alarm Range |
15-300bpm |
| Accuracy |
±1bpm |
| Lead Selection |
I,II,III,aVR,aVL,aVF |
| Input |
3 / 5-lead ECG cable |
| Sweep Speed |
6.25, 12.5, 25 mm/s |
| Amplitude Selection |
x1/4, x1/2, x1, x2, x4 |
| Frequency Response: |
| Monitoring |
0.5 to 35Hz (+0.4dB, 3.0dB) |
| Defibrillation Protection |
5kV test |
| Recovery Time Following Defibrillation |
Less than 5 seconds |
| Temperature(option) |
| Measurement and Alarm Limit |
0-50°C |
| Probe |
Skin surface |
| Unit |
Celsius/Fahrenheit |
| Accuracy |
±0.1°C(25°C ~45°C), ±0.2°C(0°C ~25°C or 45°C ~50°C) |
| Resolution |
0.1℃ |
| Respiration(option) |
| Measurement Mode |
Thoracic Impedance |
| Respiration Rate |
7-150 bpm |
| Waveform Display Speed |
6.25, 12.5, 25mm/s |
※Contents and specification subjects change without notice
|
|
